Description
Pre-Swaging Ferrules onto Tubing Pre-Swaging Dieset Standard Installation Instruction AHP and AEP Electric Pre-swaging Unit pre-swages 1/2 to 2 in. and 12 to 50 mm of M Tube Fitting front and back ferrule onto stainless steel and carbon steel tubing. To order dieset, select an applicable part number. M Tube Fittings are supplied with finger-tight position. Therefore fitting disassembly is not necessary prior to installation. For tubing installation, make sure that tubing end is prepared with a square cut, inside and outside burrs are removed. AHP unit is supplied in a sturdy plastic case containing swaging head, hydraulic hand pump, hose, and pre-swaging die set. AEP unit is built in sturdy steel case and pre-swaging die sets are supplied in separate case.

• Handy and portable for one person operation.
• Reduction in makeup torque up to 70% compared to manual pull-up. 
• Prevent body thread galling and deformation. 
• Consistent swaging onto fitting. 
• No initial strain over body seal finish and body thread.